Micro fiber towels work very well for this. Take a wood strip that iss wider than the hole, put it up inside the ceiling or wall to cover the hole and glue it down and then cover with a sheet rock patch. Test the circuit with a voltage tester to be certain the power is off. The first thing to do is determine whether or not you think you have the skills and tools necessary to install the fixture yourself or if you need to consdier hiring a professional. For the metal outlet box, select a box used for ceiling fans, a standard ceiling outlet box will support a fixture weighing less than 30 pounds. This will keep the cleanser from getting into the electrical components of the fixture. You can adjust the level at which the chandelier hangs to help it fit the room better. Safety is always the most important part of any project, especially when electricity is involved.
The tools needed are pliers, an adjustable wrench, wire cutters, wire strippers, a putty knife, a drywall saw, a carpenter's pencil, a power drill, drill bits, a flat-head screwdriver, and a Phillips screwdriver. A metal 5Pcs wrench set box for ceiling fans will support a fixture up to 60 pounds. This involves exposing the electric box by removing the canopy and then disconnecting any wires. You will need chandelier cleaner to properly care for your light fixture. Step 5: Hole Patching Now you need to patch the hole where your old fixture was. Don't forget that, after installation, a chandelier requires regular maintenance. You'll need to thread them through the electrical box. After this is done, the wires can be connected. Step 2: Remove Existing Lighting Fixtures Before you can install your new wrought iron chandelier, you'll need to remove any lighting fixtures that already exist in the desired location.
Protect the light bulbs by covering them with plastic or baggies and securing them with a rubber band. Next you'll need to install the electrical box using the expandable bracket and small bracket. You will need several parts and tools to install a chandelier. Of course you need the chandelier itself and all of the parts that come with it. Step 1: Turn Off the Power Any time you work on a do-it-yourself electrical project, be sure to turn off the circuit breaker before beginning. Be certain that the entire wrought iron chandelier is completely dry before turning it back on. Use the drywall saw and cut out the circle. If you are not comfortable with any portion of this project, be sure to look into a professional electrician. Spray down the entire chandelier with the cleaner and either let it drip dry if it's not too dirty, or wipe the entire thing down with a clean cloth. Then separate the wires and remove about a half inch of the insulation with the wire strippers.
Copyright (c) 2009 Julia Ritzenthaler Installing a new chandelier can be just as much of a project as picking it out in the first place. Remember, if your new chandelier is more than 30 pounds, be sure to change the box out for a 60 pound box. You need to turn off the power to the fixture before you clean it. Additional Tips: Make sure that your new chandelier fits the scale of the room nicely. You will also need a step ladder, a metal outlet box, wire nuts, a small wood strip, an expandable bracket (typically used for ceiling fans), a circuit tester, and a small bracket that has bolts attached. Step 3: New Electrical Box Installation For this, the first thing you need to do is use your carpenter's pencil to draw a circle in the exact location where you plan to install the wrought iron chandelier. If you are going to do it yourself, read on here for the details.. Once the light fixture is dry, remove the baggies, spray some cleaner on a clean cloth, and wipe down each bulb. Step 4: Wiring This step involves connecting the wires.
留言列表
